改性活性炭纤维吸附炸药废水中TNT实验研究

本文研究了改性活性炭纤维对炸药废水中TNT的吸附行为。研究表明:1 mol/L HNO3改性的活性炭纤维吸附效果最好,其对炸药废水中TNT的最佳吸附条件为:吸附剂用量为0.6 g/25 m L,吸附平衡时间为60 min,升温有利于吸附进行。Langmuir和Freundlich吸附等温线均能较好地描述活性炭纤维对TNT的吸附,吸附动力学分析表明,吸附过程遵循准二级动力学规律。     

新疆某石化企业污水库周边土壤对钴的吸附行为研究

采用静态吸附法研究了新疆菜石化企业污水库周边土壤对重金属钴的吸附特征,考察了溶液pH值、钴离子平衡质量浓度、背景电解质浓度、吸附时间和环境温度等因素对钴吸附量的影响,并对吸附机理进行了初步探讨.结果表明:溶液pH值为1～4时,改变pH值对土壤吸附钴的影响显著;吸附时间在3h左右时钴吸附量趋于稳定;随溶液背景电解质浓度增大,土壤对钴的吸附量呈现先急剧后缓慢的下降趋势;土壤对钴的吸附量随温度升高而增加.拟合结果表明,Langmuir和Freundlich模型能较好地描述土壤对钴吸附的热力学过程;在3h内,土壤对钴吸附的动力学过程可以用一级反应动力学方程表示.方差分析结果表明,对土壤吸附钴量有显著性影响的因素有溶液pH值、钴离子平衡浓度、吸附时间和温度等.     

固定化微生物吸附剂对Cr3+的吸附特性研究

从皮革铬鞣、复鞣污泥等处分离、纯化出4株菌株TP、XB、MY和TQ,采用海藻酸钠悬滴法并添加膨润土制成微生物固定化吸附剂,研究该吸附剂对低质量浓度Cr3+的吸附特性。结果表明,4种固定化颗粒对低质量浓度Cr3+有较好的吸附作用。实验室条件下,当吸附温度为30℃时,6 h后固定化吸附剂进入缓慢吸附和平衡吸附阶段。吸附等温曲线拟合研究表明,不同温度下吸附剂适合不同的等温模型。4种微生物吸附剂均与Lagrange拟二级动力学模型拟合最佳,且吸附量从高到低为TQ、TP、XB、MY。颗粒内扩散模型研究表明,20℃下XB和MY对Cr3+的吸附分为快速吸附和缓慢吸附阶段;30℃和40℃下固定化颗粒均呈现表面吸附—缓慢吸附—平衡吸附过程。热力学研究表明,吸附反应均属于自发进行的吸热过程,并且均是化学吸附。     

构造煤孔隙结构与瓦斯耦合特性研究

利用压汞法、低温氮吸附法、瓦斯等温吸附和解吸试验对平煤八矿构造煤和共生原生结构煤进行综合分析,探讨了构造煤孔隙结构与瓦斯耦合特性.结果表明,构造煤以微孔为主,中孔和大孔相对发育且含较多细颈瓶孔,孔隙连通性差.与共生原生结构煤相比,构造煤各孔径阶段的孔容和孔比表面积都有所增加.构造煤比表面积的增加具有阶段性,即孔径＜ 1.2 nm时为慢增加阶段,孔径=1.2 ～ 4.9nm时为快增加阶段,孔径＞4.9 nm时为稳定阶段.构造煤极限瓦斯吸附量a的增大与比表面积快增加阶段关系密切,但小于其BET比表面积的增幅.瓦斯解吸初期0～2 min内构造煤瓦斯解吸速度和解吸量明显大于共生原生结构煤,与中孔和大孔的变化一致,2 min以后瓦斯解吸迅速衰减.低煤体强度、高瓦斯含量的构造煤以气-煤共溶体形式储集更多弹性潜能,突然卸压时瓦斯膨胀能迅速释放,煤层中发育的构造煤增加了煤与瓦斯突出的危险性.     

双效精馏-吸附联合工艺处理DMF废水

提出以双效精馏-吸附联合工艺处理DMF废水。采用双效精馏将DMF废水中的DMF回收为99.8%以上的产品;采用大孔树脂对双效精馏后产生的少量DMA和DMF进行吸附,使其达到国家排放标准,并例举了该工艺在工程上的应用实例。     

Enhanced CO2 adsorptive performance of PEI/SBA-15 adsorbent using phosphate ester based surfactants as additives

In this study,a series of polyetherimide/SBA-15: 2-D hexagonal P6 mm,Santa Barbara USA(PEI/SBA-15) adsorbents modified by phosphoric ester based surfactants(including tri(2-ethylhexyl)phosphate(TEP),bis(2-ethylhexyl) phosphate(BEP) and trimethyl phosphonoacetate(TMPA))were prepared for CO_2 adsorption.Experimental results indicated that the addition of TEP and BEP had positive effects on CO_2 adsorption capacity over PEI/SBA-15.In particular,the CO_2 adsorption amount could be improved by around 20% for 45PEI–5TEP/SBA-15 compared to the additive-free adsorbent.This could be attributed to the decrease of CO_2 diffusion resistance in the PEI bulk network due to the interactions between TEP and loaded PEI molecules,which was further confirmed by adsorption kinetics results.In addition,it was also found that the cyclic performance of the TEP-modified adsorbent was better than the surfactant-free one.This could be due to two main reasons,based on the results of in situ DRIFT and TG-DSC tests.First and more importantly,adsorbed CO_2 species could be desorbed more rapidly over TEP-modified adsorbent during the thermal desorption process.Furthermore,the enhanced thermal stability after TEP addition ensured lower degradation of amine groups during adsorption/desorption cycles.     

Mesoporous carbon adsorbents from melamine-formaldehyde resin using nanocasting technique for CO2 adsorption

Mesoporous carbon adsorbents, having high nitrogen content, were synthesized via nanocasting technique with melamine–formaldehyde resin as precursor and mesoporous silica as template. A series of adsorbents were prepared by varying the carbonization temperature from 400 to 700°C. Adsorbents were characterized thoroughly by nitrogen sorption, X-ray diffraction(XRD), scanning electron microscopy(SEM), transmission electron microscopy(TEM), thermogravimetric analysis(TGA), elemental(CHN) analysis, Fourier transform infrared(FTIR) spectroscopy and Boehm titration. Carbonization temperature controlled the properties of the synthesized adsorbents ranging from surface area to their nitrogen content, which play major role in their application as adsorbents for CO_2 capture.The nanostructure of these materials was confirmed by XRD and TEM. Their nitrogen content decreased with an increase in carbonization temperature while other properties like surface area, pore volume, thermal stability and surface basicity increased with the carbonization temperature. These materials were evaluated for CO_2 adsorption by fixed-bed column adsorption experiments. Adsorbent synthesized at 700°C was found to have the highest surface area and surface basicity along with maximum CO_2 adsorption capacity among the synthesized adsorbents. Breakthrough time and CO_2 equilibrium adsorption capacity were investigated from the breakthrough curves and were found to decrease with increase in adsorption temperature. Adsorption process for carbon adsorbent–CO_2 system was found to be reversible with stable adsorption capacity over four consecutive adsorption–desorption cycles. From three isotherm models used to analyze the equilibrium data, Temkin isotherm model presented a nearly perfect fit implying the heterogeneous adsorbent surface.     

煤对CO2，N2和CH4的吸附速率经验公式与异同性研究*

为了解决吸附速率拟合公式缺乏而解吸经验公式众多的问题，通过替换解吸参数、定性和对比分析各经验公式对煤吸附CO₂，N₂，CH₄吸附速率的适用性，选取4种不同煤质的煤样在0.5，1.0和2.0 MPa下进行定温吸附实验，分析压力和煤质对吸附速率的影响规律。研究结果表明:时间函数式对3种气体在不同压力和煤质下的吸附速率拟合效果最佳；压力和煤质对3种气体吸附速率的影响既存在共性又具有差异性，气体吸附速率与压力符合指数函数关系，与挥发分呈现出二次函数关系，并且压力升高会导致最低吸附速率趋向于较高变质程度煤样；CH₄和N₂的吸附速率随压力升高而升高，而CO₂的吸附速率因煤样而不同，且在同压下，不同气体的最高和最低吸附速率煤样的变质程度也不同。     

不同类型活性炭处理废水中重金属离子的研究进展

重金属对人体的显著毒性和难降解的特性,使重金属水体污染成为全球性关注的环境问题。本文综述了重金属废水的危害、来源及常用处理方法,比较了不同类型活性炭处理废水中重金属离子的差异,阐述了不同类型活性炭处理技术的优势和特点,并对今后的重金属废水处理技术研究方向进行了展望。     

羊八井地热区典型植物对氟的吸附富集特征探究

采用水浴提取法处理羊八井地热区土壤和植物样品中可溶性氟，并用离子选择性电极法测定提取液及地热水中的氟。结果表明，地热水中氟离子最高为162 mg/L，土壤和植物中水溶性氟分别为347 mg/kg~937 mg/kg和189 mg/kg~164 mg/kg。氟离子在不同植物中的分布差异较大，嵩草属植物富集氟离子的能力最强，故可利用植物修复技术对高氟地热水、土壤净化处理，以降低氟污染。